top of page
![](https://static.wixstatic.com/media/1149de6bf15f40c587573bf9311dc32c.jpg/v1/fill/w_1920,h_1280,al_c,q_90,usm_0.66_1.00_0.01,enc_avif,quality_auto/1149de6bf15f40c587573bf9311dc32c.jpg)
Drive Gates
![20200331_154730_edited.jpg](https://static.wixstatic.com/media/a67059_01949edf94b14798aecb180c32a051b9~mv2.jpg/v1/fill/w_873,h_144,al_c,q_80,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200331_154730_edited.jpg)
![20200401_151314.jpg](https://static.wixstatic.com/media/a67059_068758fb6ecd4e16b4b73087163016e8~mv2.jpg/v1/fill/w_424,h_206,al_c,q_80,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200401_151314.jpg)
![20200401_150843.jpg](https://static.wixstatic.com/media/a67059_68367a8099524e94a98751635736af71~mv2.jpg/v1/fill/w_424,h_206,al_c,q_80,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200401_150843.jpg)
First i cut the box section to the correct length then welded it into 2 rectangles making the outline for the gates. Then i wanted to give a lip for the panel to sit against i welded a piece of 30x8 flat bar to the box section. I didnot want the end result looking like i had done that so all the weld on the flat bar was ground back ( this was a big job and very time consuming.
![20200406_171432_edited.jpg](https://static.wixstatic.com/media/a67059_2bc0c4ac06014c2b9d716baa77746c30~mv2.jpg/v1/fill/w_360,h_536,al_c,q_80,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200406_171432_edited.jpg)
![20200408_070732.jpg](https://static.wixstatic.com/media/a67059_746d51699b6e44d48dd470854126475c~mv2.jpg/v1/fill/w_349,h_536,al_c,q_80,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200408_070732.jpg)
![20200414_133718_edited.png](https://static.wixstatic.com/media/a67059_47cd985052dd48d2a6e3e6f8eaa05f81~mv2.png/v1/fill/w_768,h_557,al_c,q_90,usm_0.66_1.00_0.01,enc_avif,quality_auto/20200414_133718_edited.png)
bottom of page